INcase it goes down or deleted:
I will assume that all those reading will have base MS knowledge. Those who don't feel free to ask some questions.
1992 SLC engine/drivetrain into a 1992 GTI (my old one). Car has been running a stock chipped ECU for a little over a year. All factory sensors have been used, only addition to the engine bay is a single vacuum line for the map signal.
Wiring is straight forward from a cut up Motronic ECU connector to the MS DB37 connector. I will post the pinout below.
[MS to Motronic Pinout Placeholder]
Board built and tuned by me.
MS1 V3
MSnS-E 029t
Board mods/hardware:
VRIN - TSEL
TSEL - VROUT INV
D14 with pullup to IGN (no VB)
Both VR pots fully CCW
Launch Circuit
Tach Circuit (not working yet) w/ 2k pullup
TIP120 for PWM idle valve with 1N4001 flyback diode between output and 12v
Remove Q4, Q20 and R39. replace R39 with a wired link or solder the (E) emittor to the right side of position R39 rather than at the Q4 position.
