ojeeztutone wrote:how do i get ahold of paul vr6 and chat about the possibilities i could run. I may just end up having him configure one for me as i have a sh*t ton of stuff going on right now and i would like it to be as painless as possible, however i am on a budget and would like to avoid dropping over 500 bux on the setup.
My plans are for 83.5mm 10.5:1 pistons, complete bottom end rebuild and balance rotating assembly. 270* autotech cam, all lightweight valve train components, PnP head. Stock 1.7 accessories on the ABA block (alternator is only accessory driven off belt) I have the entire engine harness and will be buying the components i dont trust re-using like oil sending unit, oil pump etc.
ojeeztutone wrote:Well that is BA! So i just need the v3 board w/ a wiring harness that i will cut to fit my app, and a tuning cable that i will need correct? Use the factory connectors, not the whole harness. Past that its all the motor on my end and all the trinket parts i need still. Does that sound correct?
PS. You are awesome! Your insight makes me giddy for this thing to run
ojeeztutone wrote:well i got my MS2 v 3.57 setup this week and am looking to program all my sensors into the computer. How do i setup the 60-2 vr sensor? I am planning on using all ABA components for the setup (IAT CTS, Cranksensor, etc. Also can i wire a knock sensor in? if someone has a detailed writeup on this that would be awesome. I am looking for as turnkey a installation as possible when i get my motor back from the machine shop.
Users browsing this forum: No registered users and 0 guests