T1 Cheap intake idea

T1 Cheap intake idea

Postby vdubjim » Thu Jun 24, 2010 3:25 pm

One of these days ill have time to get around to trying this....... Something to get ideas rolling

there are lots of those intakes on samba.com at like 20 bones.
Image

Bore out that center splitter for more volume, throw this on:
Image
Image
rabbit vs audi. audi 5k is larger. Similar to early 90s 16v jetta/golf
there are tons that use this same bolt pattern, but have the linkage on one side or the other, different spring combos and lengths etc..
Most of the automatics had TPS factory.

To join the TB to an airfilter pipe etc..
Image
or this might fit, and the bottom is already round.
Image

Use a cable for the throttle, no linkage to mess with, you could 'adjust' the pedal by using diff length arms for the cable on the TB

Use CB encastings or mexi beetle ones.
Vintage Speedwerks
Vintage VWs / Custom Vinyl Graphics and Stickers
User avatar
vdubjim
Site Admin
 
Posts: 204
Joined: Sat Dec 05, 2009 10:28 am
Location: Oklahoma

Re: T1 Cheap intake idea

Postby vdubjim » Thu Jun 24, 2010 3:51 pm

Image

i bet something like this out of aluminium would be cheap to get in a taller lemgth to adjust your volume exactly.

Just did some research, a holley 2300 carb spacer will fit the intake just have to drill 4 holes to match. these spacers are EVERYWHERE.
Vintage Speedwerks
Vintage VWs / Custom Vinyl Graphics and Stickers
User avatar
vdubjim
Site Admin
 
Posts: 204
Joined: Sat Dec 05, 2009 10:28 am
Location: Oklahoma


Return to Aircooled

Who is online

Users browsing this forum: No registered users and 1 guest

cron
Hosted by Freeforum.ca, get your free forum now! TOS | Support Forums | Report a violation
MultiForums powered by echoPHP phpBB MultiForums