Page 1 of 1

My latest creation

PostPosted: Fri Nov 19, 2010 6:44 pm
by chips60bug
So I ditched the Mexican stuff altogether, decided to build my own from scratch, more or less. I purchased some CB IDF pattern FI manifolds and rails, and a whole bunch of pipe and then went from there...
Image
Image
Image
Image
Image
Image
Image
Image
Image
Image
Image
Image
Image

Re: My latest creation

PostPosted: Mon Dec 06, 2010 2:56 pm
by vdubjim
man awesome!!!

That the TB in the fanshroud?

Guess no internal oilcooler?

Re: My latest creation

PostPosted: Thu Dec 16, 2010 4:37 pm
by chips60bug
Thanks! The TB bolts to the shroud with a nice thick flange in between. The flange is hooked to the tube going through the shroud and into the intercooler. Oil cooler has gone external, will be mounted down by the torsion tube. Intercooler radiator will be mounted on the opposite side. Both will have ECU controlled fans installed on them. ECU is now MS3/MS3x :twisted:

Re: My latest creation

PostPosted: Thu Dec 16, 2010 4:45 pm
by vdubjim
a bit hard to see do the tubes that are where carbs would go have velocity stack type flow or are they just welded tubes?

Cant wait to see more!

Re: My latest creation

PostPosted: Thu Dec 16, 2010 5:50 pm
by chips60bug
They are just tubes. I considered doing the stack effect, but didn't have any to work with.

Re: My latest creation

PostPosted: Wed Jan 26, 2011 4:02 am
by vdubjim
it alive?

Re: My latest creation

PostPosted: Wed Feb 02, 2011 5:16 pm
by chips60bug
Not yet, but getting closer...
Image
Water tank
Image

Re: My latest creation

PostPosted: Fri Feb 04, 2011 3:20 am
by vdubjim
:o :o :o :o :o :o

Hosted by Freeforum.ca, get your free forum now! TOS | Support Forums | Report a violation
MultiForums powered by echoPHP phpBB MultiForums