Page 4 of 4

Re: MK2 Golf 2.0 8v GTI

PostPosted: Mon May 30, 2011 3:26 pm
by iZOTOPE
hello again...
it's been a while from last post here, i've changed the project a little and i've installed a g60 + FMIC on my 2.0 motor.
the install was pretty easy, a bracket needed to be modded and some blockoff plates to be fabricated.
now i'm wainting for g60 apex strips and belt, and some klubber grease.

here ar some pictures from the install:
Image
Image
Image
Image
Image
Image
Image
Image
Image
Image
Image
Image
Image
Image
Image
Image
Image
Image
Image
Image
Image
Image
Image
Image
Image
Image

it is a little ghetto, but it works, charged air isn't hot, and i hope i can run some nice ignition tables :D
my target is 200bhp in current configuraation : 9.6:1 compression ratio, stock compressor wheel.

Re: MK2 Golf 2.0 8v GTI

PostPosted: Wed Jun 01, 2011 10:17 am
by vdubjim
nice!!!!

whats the intercooler from?

Re: MK2 Golf 2.0 8v GTI

PostPosted: Wed Jun 01, 2011 2:19 pm
by iZOTOPE
it has a Renault badge, european car...don't know the model :)
it keeps charged air temperatures quite low :D

Re: MK2 Golf 2.0 8v GTI

PostPosted: Wed Jun 01, 2011 6:39 pm
by vdubjim
nice!

Re: MK2 Golf 2.0 8v GTI

PostPosted: Mon Jul 04, 2011 4:36 pm
by iZOTOPE
today a friend of mine welded the G60 outlet flange, it is made out of stainless steel, so now i won't have any boost leaks :D
here are some pictures:

Image
Image
Image

dimensions:
the inner diameter from the big side of the reduction tube is 76.1mm, and the diameter from the small side of the reduction tube is 60.3mm.
on the side that is facing the charger we cut a flange out of a 5mm thick stainless steel sheet, the inner diameter is 75.9mm and the outer diameter is 96.1mm.

and some goodies for the charger:
new apex seals, 12mm timing belt and some klubber

Image
Image

Hosted by Freeforum.ca, get your free forum now! TOS | Support Forums | Report a violation
MultiForums powered by echoPHP phpBB MultiForums